2025 UL Ordering Catalog - Flipbook - Page 26
SPECIFICATIONS
General
Power Requirements
Check valve
2¾" diameter fluorocarbon seal constructed on cast
aluminum body and aluminum backing washer
Pressure
relief valve
Syphon
Air eliminator
Electrical
disconnect
Approvals/
Certifications
Incoming power
Fixed length, fixed speed models require singlephase, 208-230 VAC, 60 Hz incoming power
Available in four pressure relief settings, integral to
check valve. Standard model relieves at 40 psi and
resets above 35 psi
¾, 1½, and
2 Hp versions
Fixed length, fixed speed models are available in
¾, 1½, and 2 Hp versions
Venturi-type syphon primer supplied with every
submersible. Syphon check valve and secondary
syphon sold separately.
Fixed length,
fixed speed
Fixed length, fixed speed models incorporate
a starting and running capacitor with internal
bleed resistor
350 volt, 1
5 microfarad
A 370 Volt, 15 microfarad rated capacitor is
used with ⅓, ¾, and 1½ Hp fixed length, fixed
speed versions
370 volt,
40 microfarad
A 370 Volt, 40 microfarad rated capacitor is used
with 2 Hp fixed length, fixed speed versions
Single phase
SPGC-220 Guardian Series™ Single Phase Smart
Controller and STP-CBS single-phase control boxes
are available for fixed speed pump control
Every submersible includes a tank return path with
one-way check valve to provide active air elimination
Electrical yoke for positive contractor disconnect
during service
−
−
−
cULus listed
Consult factory for applicable approvals
Franklin Electric is an ISO 9001
Certified Manufacturer
Pump Motor
Fixed speed
3450 rpm, multi-stage centrifugal type pump motor
with integral, automatic, thermal overload protection
¾ Hp fixed speed
¾ Hp fixed speed models are available
as two-stage versions
1½ and 2 Hp
fixed speed
1½ and 2 Hp fixed speed models are available in
standard pressure (two-stage) versions and high
pressure (H option, three-stage) versions
26
Liquid Compatibility
Max. liquid
viscosity
70 SSU at 60° F (15° C)
Fixed length STP
Fixed length STP models are UL listed for fuel
mixtures containing up to 10% ethanol with
gasoline, and 20% MTBE, 20% ETBE or 17% TAME
with gasoline
STPAG/STPAP
(AG compatible)
STPAG/STPAP (AG compatible) models are UL listed
for fuel mixtures containing diesel fuel with up to
20% Biodiesel, 100% Biodiesel, up to 85% ethanol
with gasoline, and 20% MTBE, 20% ETBE or 17%
TAME with gasoline
All fixed
speed models
Fixed length models can also be used with diesel
fuels, fuel oils, kerosene, Avgas, and jet fuels in a
non-gelled pourable state
Wetted elastomers
All wetted elastomers are made of a high grade,
fluorocarbon compound
Fixed Length Submersible Turbine Pumps
